Panels pulled loose or unlocked
Usually wind lift or nails driven too tight. We re-hang them so they lock and still have room to move.
Storm damage · Loose panels · Leaks
Panels blown loose or cracked after a storm? We fix the damage and the leak behind it before rot spreads.
What we fix
Wind does most of the damage we see. During the May 2024 derecho, the National Weather Service estimated winds near 100 mph in parts of downtown Houston, and Hurricane Beryl came ashore as a Category 1 storm that July. Gusts like that unlock panels, crack brittle courses and push rain behind trim.
A loose panel is the easy part. What matters is whether water got behind it, so we open the wall far enough to check the wrap and sheathing before closing it back up.
When the damage is spread across the whole house, patching stops paying off. Our Houston siding page covers full re-siding and typical costs.

Common problems
Usually wind lift or nails driven too tight. We re-hang them so they lock and still have room to move.
Hail, flying debris and mower stones break brittle panels. We swap out the damaged pieces without tearing off the whole wall.
Water usually gets in where trim meets the wall. We check the flashing and J-channel, not just the panel.
If the wall gives when you press it, the wood behind needs replacing before new panels go on.
We replace mismatched pieces with the closest profile and color, placed where they show least.
Finding the cause
A stain inside doesn't always sit right behind the bad spot outside, because water runs along the wrap before it shows up. We work from the top down:
What you'll pay
Most repairs typically cost $700 to $3,300, and Angi puts the local average near $1,990. By material, vinyl repairs run about $2 to $7 per square foot and wood about $4 to $11.
| Job | Typical cost |
|---|---|
| Full vinyl re-side, about 2,000 sq ft of wall | $8,000–$24,000 |
| Siding repairs, all materials | $700–$3,300 |
| Vinyl repair, per sq ft | $2–$7 |
| Wood repair, per sq ft | $4–$11 |
Typical ranges, not our quotes. Sources: HomeAdvisor (vinyl re-side) and Angi local repair data.
The price goes up when sheathing has to be replaced, flashing needs rebuilding, the damage is high off the ground, or the profile is hard to find.
Storm pull panels loose? Get the wall closed before more rain.
Call (832) 924-6020After a storm
Then call us. We'll look at what's open and tell you whether it's a repair or a bigger job.
Repair or replace
A repair is the right call when damage is in one area and the rest of the walls are sound. If panels are brittle all over, buckling on several sides, or you've patched the same spots more than once, a full re-side usually costs less over time.
Good to know
Yes. Vinyl panels unlock from each other, so we can remove the courses above a damaged spot, replace it, and lock everything back.
Not always. Sun fades panels and manufacturers retire colors, so we bring the closest match and suggest where a small difference will be least visible.
Look for soft spots, peeling paint or stains on inside walls, and musty smells near outside walls. Any of those means the wall needs opening, not just a new panel.
Small panel swaps often don't, but larger repairs may need a Residential Repair Permit from the City. We'll check before work starts.
Yes. Wood repairs typically run $4 to $11 per square foot, and we match board profiles as closely as the material allows.
Yes. Call (832) 924-6020 and tell us where the damage is.
Next step
Tell us where the damage is and what you're seeing inside. We'll look, explain what caused it, and quote the fix.